Turn K3 off, and close the K3 Utility. Restart K3 then the utility and try again.
73, James K2QI On Tue, Nov 16, 2010 at 10:14 PM, Glenn Haffly <[email protected]> wrote: > Good evening , While trying to load 4.22 I had a momentary loss of AC power > as new firmware was being loaded. Currently the front panel shows MCU LD > and > the red TX LED is flashing. The K3 utility is attempting to communicate but > , The only thing happening is a scroll of the various bps connection > speeds. > The box to send checked items and send all new firmware to K3 are both > grayed out. I unplugged the K3 for a minute , applied power and held the > power switch in for 10 seconds with no change. > > I would appreciate help getting firmware reloaded. > > Thanks , Glenn > K5ZE > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > -- 73 de James K2QI President UNARC/4U1UN ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
