Disregard , Closing the K3 utility and powering down the K3 And then restarting both , All is well now.
Glenn K5ZE ----- Original Message ----- From: "Glenn Haffly" <[email protected]> To: <[email protected]> Sent: Tuesday, November 16, 2010 9:14 PM Subject: [Elecraft] K3 Firmware Issue > Good evening , While trying to load 4.22 I had a momentary loss of AC > power > as new firmware was being loaded. Currently the front panel shows MCU LD > and > the red TX LED is flashing. The K3 utility is attempting to communicate > but > , The only thing happening is a scroll of the various bps connection > speeds. > The box to send checked items and send all new firmware to K3 are both > grayed out. I unplugged the K3 for a minute , applied power and held the > power switch in for 10 seconds with no change. > > I would appreciate help getting firmware reloaded. > > Thanks , Glenn > K5ZE > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html -------------------------------------------------------------------------------- No virus found in this incoming message. Checked by AVG - www.avg.com Version: 8.5.449 / Virus Database: 271.1.1/3260 - Release Date: 11/16/10 07:34:00 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
