See CONFIG: VFO OFS on page 62 of the current K3 Owner's manual. VFO OFS turns it on and off, and CONFIG:VFO CRS sets the tuning rate (per mode).
73 de Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Rick Stealey Sent: Wednesday, November 24, 2010 7:09 AM To: [email protected] Subject: [Elecraft] RIT/XIT offset control moves vfo A in large steps? In the K3 Utility program, ver 1.3.11.5, if you hit Help, then K3 Utility Help, and look in the Contents tab and then Help over the Web, and then Frequently Asked Questions you get to a fantastic document telling all about features of the K3. I suspect some parts of this document is out-of-date and discusses features that were changed or not implemented yet but I want to be sure because this is a feature I would like to make use of. It says, "When RIT and XIT are both off, the offset control advances VFO A in large steps, defined by the operator on a per-mode basis (e.g. 2.5 kHz for SSB, 5/9/10 kHz for AM, etc.)." This doesn't work on my rig. Is there something I failed to set up to get this to work, or is it not implemented yet? Rick K2XT ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
