I am in the course of finishing the KAT2 assembly. I did the C55 adjustment like discribed on page 16: Press T U N E button and release it when you see the display change. Adjust C55 for an indication as close as possible to 0 0 0 . Tap or hold T U N E again to cancel the C A L n display and return to receive mode
I get as close as 007 - is this normal or indicating a problem? next question: On page 17 of the assembly manual at this point: ------ Go into TUNE mode briefly. At 5 watts, the voltage should be between 3 and 4 volts. If it is much lower or higher than this, you probably have a wiring error in the SWR bridge. Remove the KAT2 control board from the L-C board and check the wiring of T1. Make sure T1's leads are properly stripped. ------ I have a reading of only 2.4 V. I checked the T1 wiring but do not see a mistake. Should I go on and add R6 or should I remove T1 and check it outside the board? 73! de Werner OE9FWV -- Think about it ..... A: Because it messes up the order in which people normally read text. Q: Why is top-posting such a bad thing? A: Top-posting. Q: What is the most annoying thing on usenet and in e-mail? Email powered by Pegasus Mail free at <http://www.pmail.com> Homepage: <http://www.qsl.net/oe9fwv/> Fone +43 5522 75013 Fax +43 5522 22505 Mobile +43 664 6340014 Fax-Email Gateway +43 820 220262990 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
