Check these two things first... Do you have the rig set in test mode? If you do the K3 won't TX in any mode. Do you have the VOX turned on? The K3 will not TX in CW mode without the VOX engaged.
73, Tom Childers Radio Amateur N5GE Licensed since 1976 QCWA Member 35102 ARRL Life Member On Sat, 04 Dec 2010 14:33:39 +0000, K4GM- George <[email protected]> wrote: >My K3 using 4.22 will put out full power in TUNE position. The ATU >works fine and delivers 1:1 swr or close. However, if I switch to CW I >get zero power out. I switched to 5 watts out and still no power out on >cw. I hear the sidetone as I key and the radio appears to go into >transmit mode because the RX is muted. RX is fine. These conditions are >the same on all bands 160-10. Switching to RTTY FSK D or PSK D I do get >full power out. AFSK A also works fine. Suggestions?? Firmware issue >or hardware problem? Naturally this happened in the middle of a contest! > >George Marzloff K4GM > >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
