I have used the K2 with the PTC-IIusb with no problem. As I remember it, Airmail talks to the PTC on one com Port and to the K2 on another. I haven't had this particular configuration set up for several years but if necessary I could probably re-create it.
I did modify the K2 to give the PTC low level access to the audio path for both transmit and receive. 73, Jim - W4BQP On 12/4/2010 8:46 PM, Brendan Minish wrote: > Airmail DOES speak K3 CAT commands > > I am not sure about the PTC modems ability to support the K3 directly > since my PTC2e does not support rig control directly. > if this is important to you then prehaps it would be worthwhile asking > SCS to add K3 support, this should be easy for them to do as it's just a > small extension of the kenwood protocol which they already support > > In my station rig control is by means of a second com port connected > directly to the k3. > Surely in almost any set-up except prehaps a dedicated pactor only > station the rig will be connected to the PC via a second com port (or > USB-RS232 adapter) for logging, firmware updates etc? > > I am unsure where the difficulty lies since full K3 control is available > via airmail and has been for quite a while > > I have very successfully used the k3 for pactor with scanning as a > private PMBO for EI6GH/MM& EI9FYB/MM > > the K3 works very nicely for pactor > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
