Hi All, I just had my first failure on the K3. I noticed both the AF & RF small knobs were slipping so I thought the set screws were loose. But closer examination showed that both knobs were cracked. I replaced them with some small aluminum ones from Radio Shack. I don't think I over tightened the knobs when I built the radio. Is this a problem with other radios? Maybe I got a bad pair. 73 Hardy N7RT
----- Original Message ----- From: "David F. Reed" <[email protected]> To: "elecraft Reflector" <[email protected]>; <[email protected]> Sent: Sunday, December 12, 2010 8:59 AM Subject: [Elecraft] K3 Questions and gripes > Hi folks; > > 2. The power switch - early serial number (1476); my power switch - > well the rubber / plastic part you press on - is starting to look > like a mouse has nibbled on it, with little divots falling off > along the top and right side edges. It is looking quite ragged. > Has anyone else had this, or know if I can replace just the > rubber/plastic part, or do I need to replace the entire switch > assembly? > > Thanks and 73 de Dave, W5SV > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
