And if you care about transmitting the cleanest signal, you'll hold the K3/10 output to 10 watts PEP. Squeezing higher power out degrades the IMD. The Power control provides some additional room to be sure everyone can make the rated 10 watts.
The same is true for the K2/10. Ron AC7AC -----Original Message----- Well, let's see if I can do this right: 15 db = 10 log (Pout / 12 watts) where 15db is the FCC maximum allowed gain. Assuming that 12 watts will drive the KPA500, we solve for Pout as: 12 watts * 10^1.5 = 379 watts So, if I did the calculation correctly, that would be legal maximum. I would suspect the gain to be less, perhaps in the 200-300 watt range for no other reason than it feels right to my mind. There may also have been an email from Lyle that mentioned something in the 200 watt range, but I'm not sure. 73, Byron N6NUL ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
