Brian... The hole is threaded to accept a corresponding bolt with an enlarged end for finger tightening. The idea is for the threaded bolt to hold a ground wire/strap to the K2. I found this arrangement difficult to use in my particular setup. So, I inserted a bolt from the inside out and then used a wing nut on the outside to hold my grounding strap. This has worked for me. YMMV.
...robert On 12/19/2010 04:29, Brian Denley wrote: > There is a hole in the back of my K2 marked 'GND'. Looking for a suitable > ground connection to my K2 I wondered if this 'hole' gets filled by an > option. What are other users using for a K2 ground connection? > > Brian Denley > KB1VBF > http://home.comcast.net/~b.denley/index.html > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > -- Robert G. Strickland, PhD, ABPH - KE2WY [email protected] Syracuse, New York, USA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
