Hey Folks, Fired up my K3 and Fldigi today for an Olivia sked and immediately noticed that I was not getting any RF output. This same setup was working fine 2 weeks ago.
Switched the meter to show ALC and saw no indication where I usually get 5 bars. I could hear the Olivia tones in the speakers, so I know the audio was getting from my sound card into the K3. Tried adjusting the mic (line) gain and I can hear it making a difference in the monitor audio, but still nothing on the ALC meter. I'm running firmware version 4.22. I verified I am in DATA / DATA A mode. I verified I am not in SPLIT with VFO B set to a different mode. I verified the rig is actually going into TX (i.e. the red TX light comes on) I verified I have filters configured for use in DATA mode. I verified that CONFIG:TX ALC was set to ON. I verified that SSB mode works with a mic plugged into the rear mic jack and MAIN:MIC SEL = RP.L. SSB mode does NOT work with MAIN:MIC SEL = Line In. I saved my configuration, did an EE INIT, restored the configuration. No difference. I did another EE INIT without restoring my configuration. No difference. I went back to beta 4.17. No difference. I went back to beta 4.10. No difference. What am I missing? Any other suggestions before I send an email to k3support? 73 -- Joe KB8AP ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
