Paul, Did you set the Line-in level according to the K3 instructions? In TX TEST mode, drive the ALC indicator up to 4 bars with the 5th bar flickering. Then use the K3 power control to set the power output level.
Many interface manuals will tell you to adjust the transceiver power using the audio drive - and while that works with many transceivers that use the ALC to adjust the power output, it does not work with the K3 since its power control is developed differently. I don't really know what the Signalink instructions say, but do follow the instructions in the K3 manual on this setup portion and ignore any others. 73, Don W3FPR On 12/30/2010 3:32 PM, [email protected] wrote: > I'm brand new to digital modes (other than CW, and packet from the 80's). > > Is anyone up to helping me get the K3 configured with FLDIGI and Signalink? > > FLDIGI can receive fine. > > FLDIGI can transmit according to my in-line power meter, with the > power set to 25 Watts, but nobody can hear me. > > I've got a subscription to gotomeeting so you can operate my computer > and we can chat via gotomeeting's built in VOIP, or I can call you on > the phone. > > I'm very computer literate, but this combination has stumped me. > > 73, > > Paul N4LCD > 770-382-1023 home > 678-986-8602 cell > www.N4LCD.com > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
