This is in the owner's manual, and there's a corresponding table in K3 Utility Help on the Crystal Filter configuration page.
I'm afraid the table will format strangely in text e-mail. The page is indexed under "filter configuration". Look for the heading "Loss Compensation". 73 de Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Sam Morgan Sent: Monday, January 03, 2011 4:08 PM To: [email protected] Subject: [Elecraft] [K3] K3 Utility settings for CW filters I have both a 5 pole 500hz and a 5 pole 200hz cw filter. What is the suggested setting for the db gain for those filters? Also I remember reading a suggestion to use the K3 utility to set the filters slightly higher than the actual width, example set the width of the 500hz filter to 550hz and the 200hz filter to 250hz I have forgotten the rational for this, can someone enlighten me, again. <g> -- GB & 73 K5OAI Sam Morgan ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
