I am working on an friends K3 (#4446), recently purchased used. When I got it, Power-On resulted in "ERR DSE." Firmware load failed, so I did EEINIT, and then the firmware loaded correctly. After going through filter setups to match the on-board filters, things seemed to be working correctly. But then I tried to increase power beyond 12w, and now I get the "ERR 12V", which my friend had seen before. When that error occurs, the KPA3 fans come on. Just for kicks, I tried to do the Tx Gain Calibration through the K3 Utility (dummy load attached), and even at the 5w level, it fails.
The seller of this K3 says none of this was happening before he shipped the unit. I need some advice on how to proceed. Tnx es 73, Randy, KS4L ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
