38,400b works well for me, with either N1MM Logger or my QSO program, YPlog. Never have any problem other than those caused by the nut behind the wheel! I use a K3 and the P3 with no issue at that baud rate.
Tom - W4BQF -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Sunday, January 09, 2011 3:50 PM To: [email protected] Subject: [Elecraft] K3/P3/PC baud rate Greetings, The P3 manual says that the P3 and K3 are ALWAYS communicating at 38400 baud, but the PC/P3 baud rate is adjustable. I'm using N1MM-Logger on my PC, and I'm wondering what baud rate others are using successfully in such a setup. (Using 38400 for PC/P3 seems to be too fast for N1MM to be rock-solid reliable. For example, N1MM's frequency display is sometimes sluggish in catching up with the K3's displayed freqency.) What works for you? 73, George T Daughters, K6GT CU in the California QSO Party (CQP) October 1-2, 2011 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
