I am a bit reluctant to post this in case it is a well worn topic - but I have searched the archive & scratched my head awhile, so here goes :
My K2 (Rev B) CALFIL/display worked OK when last run a while ago. This time, after pressing BAND "minus" and seeing the expected DAC code, pressing display showed all zeroes rather than the BFO frequency. I then pressed BAND "plus" just to see what happened, and the display very briefly showed (probably) the BFO frequency before settling on all zeroes. The effect was too fast to read. This sequence is repeatable, including following power offs & ons. I have not tried a system reset - that has to be the last resort ! In all other respects the rig is fine... 73 George G4TPV This e-mail and any attachment may contain confidential and/or privileged information. If you have received this e-mail and/or attachment in error, please notify the sender immediately and delete the e-mail and any attachment from your system. If you are not the intended recipient you must not copy, distribute, disclose or use the contents of the e-mail or any attachment. All e-mail sent to or from this address may be accessed by someone other than the recipient for system management and security reasons or for other lawful purposes. Airbus Operations Limited does not accept liability for any damage or loss which may be caused by software viruses. Airbus Operations Limited is registered in England and Wales under company number 3468788. The company's registered office is at New Filton House, Filton, Bristol, BS99 7AR. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
