John, OK, I am done with this thread. If one has to drill down in prior emails to get the information needed, I cannot help. Maybe someone else will remember your thread and come to your aid. This is a volunteer effort on my part and I do not wish to be asked to do extra-ordinary things to help. If you want a paid position to come to your aid, then the folks at [email protected] are available. I offer what I can, but I will am not willing to help if criticized for shortening a thread in a response.
73, Don W3FPR On 1/22/2011 11:46 PM, John Hoaglun wrote: > Hi Don, > > That info was in the email chain until your response trimmed down the > message. :-) > > I am using an (older) Icom HM-36 mic (and have tested with two Heil > headsets with similar results). The menu is set to: SSBA=3 and > SSBC=4-1 I also indicated that I had tested (during my original > testing) with a modulated CW signal from the computer as well with > similar results... the SSB audio is very low. > > You had asked two other questions in the original email chain: The K2 > S/N is 6119 and the SSB board was bought and assembled a couple of > years ago. > > Looking at the schematic I am not seeing much in the way of adjustments > on the SSB circuit beyond the the compression at the SSM2165 which > controlled by the MCU. > > A pre-amp is a kludgy solution IMO. (It might be ok to use it for a quick test > to see if that is the problem.) > > Thoughts? Guidance from anyone else with a K2+HM-36 ? > > > Thanks, JH > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
