When you put the rig in AM Sync the rig will follow any changes in the received signal to "Sync" with it. You will also notice that you are actually on SSB in this mode.
What you saw was normal. I hope you remember what the original setting of the Ref Osc was. The manual has a good description of how AM Sync works. 73, Tom Childers Radio Amateur N5GE Licensed since 1976 QCWA Life Member 35102 ARRL Life Member Retired Professional C# Software developer http://www.n5ge.net On Sun, 30 Jan 2011 14:12:42 -0800 (PST), w0ih <[email protected]> wrote: > >I noticed that when I went to AM-S (AM Sync, AutoTracking), that the >frequency showed: > 10.000.010 > >So, I figure that the Reference Oscillator was off a bit. So I tweeked the >oscillator slightly until the frequency showed 10.000.000 when I when out of >the Config Menu. > >Is there anything wrong with this logic? > > I couldn't seem to hear beat oscillator when I get close to the 10 Mhz >signal to adjust it by the manual. > >Mike ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
