NO9E wrote: > APF was different story for RUN. Turning on APF was too slow. Having an > option to switch XFIL and APF for CW only would be great. I guess software > APF toggle change via PF key may be good enough.
I never used APF in the CQ 160 (who has time to tune in 5 Hz steps using SHIFT or 1 Hz steps using VFO?) but here's a good tip for casual operating from Wayne N6KR: Use Preset I and II to toggle APF On and Off more quickly. You can also set different XFILs using the Presets. > Some gremlins got into N1MM here. Every so often, written callsigns would > disappear, SPLIT would show up, and work frequency would change from 1820 > to 18200. Reloading CONFIG would cure it. Not sure whether it was KUSB, RF > or Vista. I had a few problems like that but not sure it was N1MM. I normally operate SPLIT on my run frequency so I can use the BIG VFO A knob to tune RX (leaving my TX fixed on VFO B). Occasionally I noticed VFO B was not on my run frequency! Could be I touched the VFO B knob (which is a good reminder to always LOCK VFO B when operating like this). If I was suddenly calling CQ on top of someone else, my apologies! 73, Bill -- View this message in context: http://elecraft.365791.n2.nabble.com/P3-APF-and-diversity-in-CQ-160-contest-tp5995363p5995500.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
