Also, remember to turn the K3 power off and then on after loading firmware.
Fred Cady fcady at ieee dot org > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of K5WA > Sent: Saturday, February 05, 2011 7:56 AM > To: 'Elecraft reflector' > Subject: [Elecraft] K3 Firmware Reload Reminder > > I know this gets mentioned regularly but it sure worked for > me today. I got > a very strange behavior after loading FW 4.25. My S meter > would jump to > full scale whenever I reduced the bandwidth below 500 Hz and > the RX would go > dead. After a lot of head scratching and unplugging of > cables to eliminate > issues, I reloaded 4.25 and everything just worked perfectly > again. I guess > the bits and bytes get crossways occasionally and a nice reload puts > everything back in order. I hope you think of this faster > than I did if you > ever need a bit of help. > > 73, > Bob K5WA > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
