Jim, That would likely indicate that the dot and dash contacts of the paddle are shorted together. Make sure the Stereo plug is fully inserted into the Paddle jack. If it persists, insert a stereo plug with no wires connected (use TX TEST), then on the back of the inserted plug, short only the tip to the shell - do you hear dits? Short only the ring to the shell - do you hear dahs? If both the above check are correct, there is no K3 problem - check your paddles and the cable. OTOH, if you get alternating dits and dahs in the tests, contact [email protected].
73, Don W3FPR On 2/5/2011 3:11 PM, [email protected] wrote: > I just bought a loaded used K3. I have a problem with the cw. I plug in a > paddle and it only sends dit dah from either paddle. I've gone through the > menu and config and can't figure out if I'm doing something wrong or I have > a problem. I loaded latest update too. > > Help a newbie > > Tnx > 73 > Jim > K5AUP > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
