Yes, two wire jumpers are needed. One between CB J1 pin 1 and J2 pin 1 - the other between J1 pin 2 and J2 pin 2. The original jumpers were soldered, but component leads bent ans stuck into the J1 and J2 headers will work quite nicely.
73, Don W3FPR On 2/10/2011 4:42 PM, [email protected] wrote: > If I were to remove the DSP module, what would I need to do to return the > K2 to operate without it? Perhaps a couple jumpers? Tnx Geo/W2BPI > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
