After you are on b30, hit the RIT/2/CLR button to get b80 and then press/hold Edit to turn it on. -- Moe - AB8XA ARRL LOTW, eQSL, Fists #13020, SKCC #7460, FPQRP #2617, NAQCC #5352, QRP-ARCI #14326
On Feb 14, 2011, at 4:50 PM, wunger (William Unger) wrote: > Hello: > > I was changing some of the settings on my KX1 in anticipation of the > SPAR Winter Field Day and FYBO. I have had the KX1 with the ATU and > 80/30 options for several years and it worked fine. > > I changed a lot of parameters and was not pleased with the way it > was operating so I decided just to do a complete reset to the > factory settings and that went fine. > > When I turned it on I only 3 bands (when I push the band switch) > starting at 8, 9 and 14 MHz and I cannot tune below 5 MHz > > I have turned on B30 in the options and did another reset as well > with the same results. I can receive between 5 and 14 MHz and > transmit on 14 MHz It did operate on all bands before the reset so > I assume it is not a hardware or soldering problem per say. The > software revision says its 102. > > Any ideas? > > Thanks, > > Bill VE3XT > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
