Once additional connections and coax length is introduced into a load that is not the same as the output impendence you will not see the same. I have come to accept that the results will be different in-line, unless some tuning is added to each measurement device to remove the circuit reactance created by each device. I accept the difference and use remote tuning to eliminate these issues.
Bill K9YEQ -----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Dohn Smythe Sent: Sunday, February 20, 2011 11:10 AM To: elecraft@mailman.qth.net Subject: [Elecraft] K3 + W2 Is there an accurate way to utilize a W2 with the K3/ATU combo? Seems that with the W2 between the output of the K3 and the Antenna, the peak reading would not be accurate. Especially at QRO power settings. I don't remember seeing anything in either of the menus that would assist with that. 73 Dohn Smythe N8EWY ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html