Vidi, The solution is on the VFO A display. If in fine there are three decimal digits. Tapping while in fine mode gives you two decimal digits, coarse mode gives one decimal digit and tapping rate gives you two decimal digits. In any case tapping fine gets you back to three decimal digits.
What am I missing here? 73, Tom Childers Radio Amateur N5GE Licensed since 1976 QCWA Life Member 35102 ARRL Life Member Retired Professional C# Software developer http://www.n5ge.net On Fri, 25 Feb 2011 17:14:49 +0200, "vidi" <[email protected]> wrote: >Hi David, > >What you and others told me is fine. However, I use the RIT control for large >freq excursions and very seldom use [FINE]/COARSE hold method. > >The [RATE] /LOCK push button is a cycling switch. Tap once for slow rate and >tap again for high rate etc etc. So, what I wood like, if possible, is to >know which rate is selected, after being side tracked here in the shack, >without having to find out by turning the main dial or by punching the button >again to see which digit will be flickering. So, my request is to find out >how if it is possible to change the freq readout so that in slow rate, the >display would show up to 10Hz readout and fast rate only up to 100Hz >readout, similar to the COARSE mode, but alternates between fast and slow >tuning rate. > >Thank you for the thoughts >73 >Vidi - ZS1EL >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
