Hi. I finally figured out how to set, adjust the level and reset/clear the SWR alarm on my new W2 wattmeter.
I had been trying to command the W2 to change the alarm setpoint simply by sending a [ or ] from the command tester in the W2 utility, but inputting [ or ] followed by <enter> always returned [44; each time. I re-read the command reference (which, by the way Elecraft, is about as obscure and geeky as it could conceivably be!) thinking I was sending the wrong command, but apparently not. Next, I tried putting the [ command in a macro, and that did the trick: each time I send the [, the W2 reduces the set point, and ] increases the set point. Curiously the [ and ] now work whether I use the macro or directly enter the commands. 73 Gary ZL2iFB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html