John, Forget the ALC - that amplifier only generates ALC when it is overdriven. There is no provision for protecting that amplifier from fault conditions such as that which exist with modern solid state amplifiers. Adjust the power of the K3 to properly drive the amplifier and all will be well. Do NOT use the amplifier ALC to reduce the K3 output, that will only lead to a distorted signal. If you insist on using the ALC line, it connects to the K3 ACC connector on pin 15. If your K3 is an older one shipped before Dec 10, 2008 (approx s/n 2362 and below), your K3 cannot use negative going ALC unless you do the mod to change it ir replace the KIO3 board with the REMIOUPGD.
The amplifier relay line connects to the K3 KEYOUT jack on the back of the K3. One caution - if that amplifier has the original relay, you may find it is too slow for full QSK with the K3. Others who have more experience with that particular amplifier than I can give you more information on that topic. 73, Don W3FPR On 3/5/2011 5:06 PM, John wrote: > Hello All- > I need help hooking up an Ameritron 811h amp to my k3. Don't want > to mess things up off the bat. Where does the ALC out of amp go to the > k3 and Relay on amp goes where on k3. First time using an amp. Any > help would be great. > > Thanks > John > km5ps > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
