Ross, Who knows what the L and C values are that are in your T1 until you do a TUNE. The incication of a low SWR when the T1 is in bypass indicates that there is residual reactance when in non-bypass. Doing a TUNE should straighten things out. The settings are remembered by band, so do a TUNE on each band.
73, Don W3FPR On 3/6/2011 8:22 PM, Ross Primrose N4RP wrote: > OK, so I finished the build yesterday, and today, after I built another > BNC-PL259 cable so I could hook it up, I did the performance tests. > Everything seems OK, except the transmit power display tests. The T1 > shows the correct power level, but the K3 indicates at>10:1 SWR during > the power measurement. Bypass mode works fine, if I put the T1 in > bypass and hit the tune switch on the K3 the dummy load gives a 1:1 SWR, > it's only a problem when trying to display power.... > > Ideas? > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
