Howard wrote: Other hams say my USB sounds tinny, lacking in bass, on 20 meters, that's the band I'm on these days.
On spectrogram, the received audio curves look great. What is the process for "on air" adjusting of the filters for better transmit audio? Is this process archived somewhere? ----------------------- Are you looking at FL1 on Spectrogram? FL1 is the ONLY filter/BFO setting combination used on transmit, regardless of which filter you have selected for receive. Still, as the Elecraft SSB module manual says, the final adjustment of your BFO setting often must be done by listening to your signal. Spectrogram gets you "in the ball park", but it's not always close enough. The "stock" K2 SSB filter is intentionally a very narrow filter. It's just about 2 kHz wide. That's wide enough for excellent intelligibility while being as narrow as possible for the greatest "punch". The narrower the bandwidth, the greater the signal-to-noise ratio. But the narrow bandwidth requires very careful adjustment of the BFO frequency, and it should be checked with the mic you are using and, preferably, with your voice. "Tinny" suggests that the bandpass is too far from the suppressed carrier, cutting off too many lows. One excellent way to check your signal is to transmit into a dummy load while monitoring your signal on an auxiliary receiver. You'll want to record your voice since it's impossible to hear what you really sound like on the air while talking. There's too much bone conduction in your head that fills in spectrum that many not be coming through the rig for your to be able to tell accurately what other operators hear. If you don't have a suitable receiver, perhaps a buddy will do some checks for you on the air. In that case you can plug in your test probe into the BFO Test point, get on the air and hook up with your buddy, then try making small adjustments in the BFO frequency for FL1 while he listens to the difference. You'll have to switch to CAL FIL, chose the filter, make a small adjustment in the BFO frequency, then switch out to make the new BFO value get read into memory. Keep a note of where you started and work in small increments while your buddy reports on how the sound changes. If your buddy's ears are good, his tuning precise and the filters in his rig aren't drastically altering your signal, you can make your final adjustments that way. Be sure to check and adjust both Upper and Lower sidebands. You can do both sidebands on any band. Ron AC7AC _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
