Jim and all, Some just have not "gotten it". The K3 is soundcard digital ready. Just connect the computer Line in to the K3 rear panel Line Out, and the computer Line Out to the K3 Line In, and set the "mic sel" menu for data modes to Line In.
Yes, if you only have speaker out level from your computer (most have line level out), then a resistive divider is in order - nothing exotic - as Jim pointed out, two resistors will do the job. 73, Don W3FPR On 3/22/2011 11:01 PM, Jim Brown wrote: > On 3/22/2011 7:24 PM, Edward Dickinson III wrote: >> The matching network is a $20 item from an auto sound store and is >> used to cut speaker level down to line level. > You just spent $20 on something that you could have done equally well > with two 5-cent resistors, AND that probably was not needed in the first > place. > > Study the part of http://audiosystemsgroup.com/HamInterfacing.pdf that > talks about audio levels. Also see the Appendix on audio that is part > of http://audiosystemsgroup.com/RFI-Ham.pdf > > The executive summary -- most computer sound cards clip at about 1 volt > sine wave. A 2-watt power amp, typical for ham gear, would clip at about > 2 volts, and that only occurs on very loud audio peaks. All that's > required to prevent clipping of the sound card input is to turn the > speaker output gain down a bit. > > A simple voltage divider (the two resistors) IS needed to drive a MIC > level input. > > 73, Jim K9YC > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
