Mark, Do you have the KAT2 installed in that K2? And if so, did you change the KAT2 R6 to 470 ohms as mentioned in the manual - the K60XV kit includes the 470 ohm resistor.
73, Don W3FPR On 4/2/2011 5:46 PM, Mark Adams wrote: > Hi Gang, > > Setting my XV222 and XV432 up to run with my K2/10 with I/O has been an > issue and I just found out why. With the K2 set for LP, split path, the > power out at the phono plug is not 1.0 mW as setup in the menu, but 0.2 mW. > The transverters work FB when set to single cable and HP, say 5W drive. > > I figure that the K60XV has a problem. The manual says to check the parts in > the LP path. Without any RF voltage info to go with, I figure that just > replacing Q1, D1, and D2 will likely solve the problem. It's a shotgun > approach, but looks reasonable to me. > > Comments? > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
