I bought both a 4-band and 2-band filter board for my K1. I built the 4-band board for 40, 30, 20, and 15 meters.
I have parts to make the 2-band board either 80/17 or 80/15. I've also considered the 160/80 option. That's not what's bothering me. Here's the question: What's really going to be involved when swapping boards? Beyond the physical removal of one board and installation of the other, there are menu changes to make to identify what bands are installed. What about calibration? In the documentation for the 2-band board it indicates the K1 can remember settings for 4 bands so it's not necessary to re-calibrate every time you swap boards. They must be thinking I'm swapping two 2-band boards because 4+2 is six bands to remember. Anybody else using this configuration and can tell me what all I'll have to do every time I switch boards? My other alternative is just to forget the 2-band board and move on to building K2 #4941 which is sitting in its box ready to be built. I just feel like I should finish all the K1 options before moving on to the K2 otherwise the K1 will never get done. Craig NZ0R K1 #1966 K2 #4941 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
