----- Original Message -----
From: "Ian Stirling G4ICV, AB2GR" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Thursday, June 02, 2005 12:27 PM
Subject: [Elecraft] K2 #4962 status
About to start on the RF board.
Resistance checks on the other two are fine.
--
Ian, G4ICV, AB2GR
Don't let the resistance checks fool you. My front panel
and control panel checked out OK but later I found a
solder blob on the power pot, a cold joint on the LED's
resistor pack and I had swapped the xtals on the Control
board.
Later I had the RF deck fully built and it checked out in
both resisitance checks and current draw but it turned
out I had wound T5 backwards and a diode installed
wrong on the SSB board.
Take your time & be carefull!
--
Just my 2¢ worth... 73's es gd dx de Ken KGØWX
Grid EM17ip, Flying Pigs #-1055, Digital On Six #350,
Proud builder & owner of Elecraft K2 #4913
--
Checked by AVG Anti-Virus.
Version: 7.0.322 / Virus Database: 267.4.1 - Release Date: 6/2/2005
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
