There was a bit of talk on this and hopefully not having to use two y cables etc. I think Elecraft said that this issue would be addressed with the new cable.
I hope so. On 4/24/2011 2:09 PM, AB3EN wrote: > Will the KPAK3AUX have a provision to tap the CTRL line?? I have the PR6 > Low-Noise 6-Meter Receive Preamplifier attached to the K3. If not can I get > access to the pins in the connector? > > "When the control (CTRL) is used and jumper P2 is removed (see Figure 3), > the K3 may be configured so > that the preamplifier is switched on only when the 6 meter band is > selected." > > Any of the Beta testers worked with issue? > > Dan > AB3EN > > ----- > > Dan AB3EN > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/QRO-KPA500-and-the-KPAK3AUX-tp6301471p6301471.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
