Hi All,
I just finished all the mods to bring K2 #402 to the current standard.
I keep getting a collector short to ground when starting to tighten the
bolt going through the heat sink of Q7. Q8 is fine. I have taken the
case off several times and inspected all the components.
Is there a trick to this, or do I need to order a new hardware set?
The plastic standoffs look a bit like truncated cones and the black
shoulder washers don't have much of a shoulder anymore. It has worked
for six years, but it might be time to replace the stuff. I was hoping
to get it on the air today, but........
Regards,
Steve, W2MY
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
