Vic Rosenthal wrote:
If you are getting 10 watts output when you set the power control to 10
watts, check the current draw at this power level by tapping Display.
You should be drawing less than 3 amperes in this condition. Check also
at 11 watts, with the KPA100 on. It shouldn't be much higher.
I should have said 'with the power control set to 100 watts', not 11 watts.
--
73
Vic, K2VCO
Fresno, CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
