----- Forwarded Message ----- From: [email protected] To: [email protected] Cc: [email protected] Sent: Saturday, May 14, 2011 1:55:52 PM Subject: Receive Align K1 #2999
Please help... I finished the receive section. The VFO adjust went great. I then hooked up my FT 450 D to a dummy load and lowered power to 5 watts. I can not hear the signal or anything else. I just hear static (I have a 40 meter ant connected to the K1). When I press my finger on T2 and move it a little :the static / noise level jumps up and I can hear a broadcast station faintly All of the voltage checks on page 7, appendix E checkout except:.The following seem a little off on RF-U4 Per manual- Actual Pin 6 6.6v -- 5.1v Pin 7 13.6v -- 10.6v Pin 8 6.8v-- 5.95v I am having a great time on the build but need some help 73 Don K4YND ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
