Hi all, When launching the W1 software, it will always give an error message: "No W1 found. Please check your computer's COM settings....."
After clearing this message, the W1 and software work normally. Another false error message is generated when I click on "Settings" then "Save": "Error saving to EEPROM." However, the settings DID save to EEPROM!! Any clue why these error messages are generated? 73 N5BCN - Brian ----- K2 #6800 KPA100/KAT100-2, KSB2, KAT2, KIO2, K160RX, KNB2, KAF2, LP-PAN/K2 w/ Pre-amp, SignaLink USB -- View this message in context: http://elecraft.365791.n2.nabble.com/MM-W1-software-false-error-messages-tp6375594p6375594.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
