Brian, I am relpying out of "stupidity". The K3 Utility tries to set the ATU to bypass. If it detects the KAT3, but it does not go into bypass, that would terminate the procedure.
I suggest that he look at the KAT3 situation first. Once that is resolved, then other factors will either fall into place or will present themselves as a different problem. 73, Don W3FPR On 5/26/2011 8:05 PM, Brian Alsop wrote: > I'm posting this for KK4AOA. He will be joining the group later. > He is doing a clean build. > > The K3 is a K3-10 so far with an internal antenna tuner and five > filters. No subrx. > > Running the utility program transmit power calibration works fine on > 160,80 and 60M but fails on 40M. > > Over the phone, we reviewed his crystal filter setup, redid the > synthesizer calibration. Except for the above things seem to work. > > Suggestions at where to look next are welcome. > > He is unable to do the 5W wattmeter calibration because of no wattmeter. > Hopefully the factory settings are close enough. > > There is also some ambiguity in that process. It tells you to put the > AUT into the bypass mode (hold ATU). However, his K3 says the ATU isn't > installed. (Two pages earlier in the manual under menu option "enables" > it says to set KAT3 to BYP, which he did). These seem to be at odds > with one another. Or does this indicate some potential problem with the > KAT-3? > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
