I found the issue. Had the filter in the wrong slot. On Sat, Jun 4, 2011 at 1:50 PM, Don Wilhelm <[email protected]> wrote: > Steve, > > Have you done the first step in the Calibration Procedures? Go to the menu > CONFIG: VCO MD, set the parameter to CAL and exit the menu to allow the > routine to run. > If you do not see that menu item, go to TECH MD and turn it on, then you > should see the entry. > > 73, > Don W3FPR > > On 6/4/2011 1:06 PM, Steve Coates wrote: >> >> I just finished building my K3/10. For one of the calibration steps I >> am trying to receive WWV. It seems that receive is not working on the >> K3. I have a steady hiss no mater if it is hooked to a dummy load or >> an antenna. >> >> This is a basic K3 with no options. >> >> Any ideas? >> Steve >> N8JAF >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
