>From Hamvention, I ordered the KX1 with the ATU, the paddles and the 3080 mod kit. They arrived a couple of weeks ago. This is going to start a line of firsts for me: first major kit, first time learning CW (in a serious fashion), first time into qrp, etc. I'm excited to start, but a bit intimidated at the same time. However, I have a need for some advice as I go forward.
I've started the parts inventory and, when I got to the 3080 mod kit, I also found the power output mod kit. My question is: can I install the power output mod while I am building the KX1 basic radio since it replaces only two resistors? Or, should I wait until after the KX1 is assembled? Does it change any of the checkout readings? A number of years ago, I bought a XYtronics soldering station. I've had some minor difficulties getting replacement tips for the iron. I ordered and received several different sizes, but I'm not sure any are optimum for this kit. I have a 1/16" chisel, a 1/64" conical, and a 1/32" conical tip. They apparently have a 1/32" semi-chisel, but I haven't found one anywhere yet. Is it possible to grind a small chisel surface on the 1/64" conical tip? Does this cause any issues with the tip or with the soldering operation? Is the 1/16" chisel small enough to do this kit? One more inventory to finish, then on to soldering... Thanks in advance for your help. Ken Race - AB8GQ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
