Hi Ron, Check Figure 5-9 on page 27 of the rev. H manual - the spacers are used only temporarily to set the height of the backlight assembly prior to soldering its pins in place. I suppose any other means you might devise to keep the backlight 1/8 inch off the front panel board and parallel to it would be acceptable (presuming you can extract the spacer after the backlight pins are soldered :) ). Don, W3FPR may have a better suggestion.
73, Mike, K8CN -- View this message in context: http://elecraft.365791.n2.nabble.com/K2-Front-Panel-assembly-question-tp6485680p6489056.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
