Don, your knowledge of the K2 knows no bounds! RX and was indeed selected for 75 meters. I turned it off and once again have good "ears" via the Lil Tarheel. Thank you very much.
73, Chuck, NN7U -----Original Message----- From: Don Wilhelm [mailto:[email protected]] Sent: Friday, June 24, 2011 5:52 AM To: 2Cents Cc: [email protected] Subject: Re: [Elecraft] K2/100 75 meters lost receive Chuck, The usual cause for "no receive on one band" is that the RX ANT has been selected for that band. While on 80 meters, enter the menu and check to see if it is on or off. 73, Don W3FPR On 6/24/2011 1:03 AM, 2Cents wrote: > Hello group, > > My K2/100 with KAT2 seems to have lost recieve on 75 meters only. It > transmits fine there but upon releasing the mic it sounds like the > coax has been cut. This is in a mobile installation using a > screwdriver antenna with a swr of less than 1.2:1. It matters not > whether the ATU is in line or bypassed--receive sensitivity is very > low. If I tune my antenna analyzer to the same frequency and hold it > close to the radio it will pick that up and display an s-meter reading, so I know it's not stuck in transmit. > > All other bands work normally. > > Where do I start? > ----- No virus found in this message. Checked by AVG - www.avg.com Version: 10.0.1382 / Virus Database: 1513/3722 - Release Date: 06/23/11 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
