Hi, Roger. What's in a name? Herein lies some of the confusion. On the K3, the 100W amp is the KPA3, not KPA100 (K2 amp). As to your problem, would it not be more efficient to use the low level output available from the KXV3(a) to drive your transverter? This would eliminate the waste of all that power in the dummy load, and provide a cleaner output, as the K3 LPA board (12w amp) is not used, I believe. Good luck, Bruce, N1RX > I should have said that it is a K3 I have. > Is it possible to change the cut-in point of the KPA100 ?? Mine seems fixed > at 13 watts. > The problem is (ref page 39 - Using Transverters) is that you cannot set XVn > PWR to more than 12 watts. Thus you cannot get the clean signal from the > KPA100. > Roger - G4BVY
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
