Hello guys,
When I connect my K2 to a dummy load, the S-meter will lit up with one
LED but *only* on USB mode when in receive.
The SSBA is set to 2
I did go through the S-meter alignment procedure but it didn't help.
Any suggestions what this could be?
Second
How good is the Elecraft Noise-Blanker unit?
I'm living in an area with quite a lot of motor QRN (Ventilation boxes).
The NB isn't doing anything with that.
I also have a Drake TR7 (great radio) and the NB is reducing the rattle
with more then 30 dB!
How they did it, I dont know but my Ten-Tec Paragon can't beat the TR7
NB as well.
Is there a good way to check if the NB is working properly or as intended?
Thanks for answer(s)
Evert, PA2KW
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
