K3 beta-test firmware revision 4.39 (with DSP rev. 2.73) is now available. See detailed release notes below.
Please send any questions to [email protected]. For instructions on how to load beta firmware, see: http://www.elecraft.com/K3/k3_software.htm 73, Wayne N6KR * * * MCU 4.39 / DSP 2.73 July 6, 2011 * NEW AF MIXER COMBINATIONS (CONFIG:L-MIX-R): Added AB A, B BA, B B, B A, A A. These may be useful for “SO2V” operation and various DX/ contest scenarios. ("A" refers to the main receiver, "B" to the sub.) * KAT3 IMPROVEMENTS: T/R timing and power thresholds changed to improve SWR measurement sensitivity. * P3 and PC NOTIFIED ON RX ANT CHANGE: Switching RX ANT on/off now informs the P3 and a connected PC of possible changes to the preamp and attenuator settings. These are stored separately for the RX ANT on and off cases. * ADDED "SMH" COMMAND (high-resolution S-meter): This is presently experimental; it is intended to work with W8WWV's “S-meter Lite” program. "SMH;" responds with "SMHxxx;" where xxx is approx. 005 @ S-1, 040 @ S-9, and 100 @ S9+60. Resolution is approximately 1 dB. NOTE: The value returned will probably be adjusted after testing.“BG” (BAR GRAPH) REMOTE CONTROL COMMAND: Added 'R' or 'T' at end of this command to indicate RX (S units) or TX (watts). ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
