As I am (almost exclusively) a cw operator, I had not noticed this until recently. On 6 meters (and only 6 meters), when I first turn on the K3, if I am in ssb mode, the audio level (output) seems to be very low. However, as I continue to speak, it gradually (a few seconds) builds up to normal output and behaves normally until I turn the radio off. I suspect this is an audio issue, as I have full output on cw from the first dit. SSB operation on other bands is normal. I set the audio levels and compression using the operator's manual instructions, but only after the output has built up. Are audio (mic) settings are band specific? Should I do my setup from a cold start and not after the output has normalized? I suspect this is operator error of some kind, but just can't seem to sort it out. Anyone have any ideas?
Bob K5SM ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
