Hi, I hope this is the right place for this post, although I'm sure it's not because its kind of a dumb question.
I've been assembling a K3 and I'm up to the point for doing resistance checks in the assembly manual on pg. 44. And yet I know nothing about resistance checks (or electronics). I'm worried about the 1st check where I'm supposed to check the 12VDC IN connectors on the rear panel. I bought a Fluke 117 DMM, switched it to the Ohm sign, its set to auto ranging, then I put the black pin in the black 12V connecter of the K3, put red on red (made sure the pins are touching metal in the connectors) and I'm not seeing anything (just 0L on the display of my DMM). And I've also stepped through the manual range settings as well, but to no avail. However the following checks on pg. 45 showed me some numbers. I can't tell if they're good numbers yet as I'm trying to figure out the decimal places and if they match what the manual says, but at least there I'm seeing numbers. So I was afraid to plug it in and do the initial power check. Can anyone comment? Much appreciated. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
