I was checking the fit of the shield on the KPA100 project that I'm building for K2 #6997 and found that the shield holes are off by the thickness of the back panel. If I match the back edge of the shield with the back edge of the back panel, all 7 holes match exactly, but the back standoffs are too short to reach the shield. If I place the shield against the inside of the panel, then the holes don't match up.
I have the drill press attachment for my Dremel tool. Should I slot the holes so the shield sits flat on the standoffs? Or am I misreading how the shield is supposed to fit on the standoffs? It lays perfectly flat on the standoffs as long as the holes don't match up. Thanks. 73 Russ WD5RS Elecraft K2 #6997 10-10 #37287 FISTS #9162 Grid EM12mc ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
