----- Original Message -----
From: "mc" <[EMAIL PROTECTED]>
To: "Ron D'Eau Claire" <[EMAIL PROTECTED]>
Sent: Tuesday, June 21, 2005 9:43 AM
Subject: Re: [Elecraft] KX1 built in dummy load
thanks,
I had a spare wire wound resistor and in error thought it might simulate
a long resistor wire. I will get the correct resistors. I have changed the
antenna to east-west instead of north-south, and I am getting good output
now, This has been a learning curve but I am thank full for this group, no
matter how much book reading I did, I would not have been able to get this
far with out the extra helpful information, thank you for all. By the way
I have given up trying to get response on 7118 as I get too much Spanish
speaking interference I guess from Mexico, I So I am now trying on 14118,
I don't have the 30 meter board assembled yet.
MC -- KB7DPC
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
