Dan WG4S wrote: Ron: did you check the output frequency? The way I understand the K2 design, if you select a freq it can't do, it'll do something anyhow. 100W on the wrong freq is not particularly useful<g>.
(Of course you know better than this, but you didn't say and I had to ask!) --------------------------------- GOOD CATCH Dan! You are so right. The K2 PLL just stops changing frequency when it hits a tuning limit. I was thinking of output LP filter issues and not what the PLL might do. In my case, it actually transmits on all of these frequencies except 4872: 3308 kHz 4872 kHz - actual 4048 kHz 7633.5 kHz 13927 kHz My K2's PLL stops at 4048. Most of them will tune higher, but I don't know how much higher. Thanks! Ron AC7AC _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
